Empirisoft Support

    Welcome to Empirisoft Support
Results 1 to 3 of 3

Thread: Cable to send DirectRT TTL signal to a BNC input

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 11-10-2008, 09:39 AM #3
    deconroy
    deconroy is offline Member
    Join Date
    Sep 2007
    Posts
    9

    10V, not 10mV

    Hi John,

    10mV is the minimum input - sorry for the confusion. Does that make the problem any easier to solve?

    There are tech specs for the other DAQ at http://www.dataq.com/support/documen...s/720_730b.pdf (the lab I'm collaborating with on this project is using the DI-730).

    David
    Last edited by deconroy; 11-10-2008 at 09:51 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. MediaLab: receive TTL signal
    By rothers27 in forum MediaLab Older Versions: General Questions
    Replies: 1
    Last Post: 05-15-2008, 02:24 PM
  2. input file crashes DirectRT on 1 computer
    By sjlee0623 in forum DirectRT Older Versions: Troubleshooting
    Replies: 3
    Last Post: 12-11-2007, 07:20 AM
  3. Sending TTL signal from one computer to another
    By jarvis24 in forum Hardware: Troubleshooting
    Replies: 2
    Last Post: 11-12-2007, 05:52 PM
  4. TTL signal to Biopac
    By XeniasD in forum MediaLab Older Versions: Troubleshooting
    Replies: 1
    Last Post: 12-15-2006, 02:26 PM
  5. TTL signal to Biopac
    By XeniasD in forum Hardware: Troubleshooting
    Replies: 1
    Last Post: 12-15-2006, 02:26 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules