Problem with 'Select and run a single questionnaire'

[prnowlin]

Hello,

I am unable to run any questionnaires (or select any other options) through the drop down menu when I am logged in as an experimenter. Interestingly, when I use an administrative account, I don't seem to have any problems. I've tried giving the experimenter account full permission over the media lab program and even change the account into an administrative account, but the problem is still not resolved. We have run approximately 60 interviews on this computer without any problems, so it is not clear why this would happen out of the blue. We also have a similar set up on seven other computers and this is the only one that freezes anytime drop-down menu is used (file path for all computers: c:\ubafdp\parent\parent questionnaires\questionnaires\). We are under time constraints so although we would never figure out why this is happening, so I just reinstall the program?


Thanks

[jarvis24]

Can you tell me the contents of the following file:

C:\MediaLab\Ini\LastExp.ini

And then can you delete contents, save it, and try again?

[prnowlin]

The ini file has the following lines of data:

c:\ubafdp\parent\target caregiver questionnaire\questionnaires\target parent part v.exp
c:\ubafdp\parent\target caregiver questionnaire\questionnaires\target parent part iv.exp
c:\ubafdp\parent\target caregiver questionnaire\questionnaires\target parent part iii.exp
c:\ubafdp\parent\target caregiver questionnaire\questionnaires\target parent part ii.exp
c:\ubafdp\parent\target caregiver questionnaire\questionnaires\target parent part i.exp
c:\ubafdp\parent training\target caregiver questionnaire\questionnaires\target parent part i.exp

[jarvis24]

Did deleting and saving the contents of that file have any impact?

[prnowlin]

No, even after deleting these files. The program freezes whenever I try to run an experiment or questionnaire file.

[jarvis24]

Well if it's just one machine out of a batch, next thing I would try is an uninstall/reinstall.

[prnowlin]

I just reinstalled the program and I am still having the same problem. Although I am not sure why it would be the case for just this machine, could have something to do with the fact that the program is being run from a 'limited access' account rather than an 'administrator' account?