Empirisoft Support

    Welcome to Empirisoft Support
Results 1 to 2 of 2

Thread: sending a ttl when a response is given (case 22421)

  1. #1
    Join Date
    Jan 2016
    Posts
    2

    sending a ttl when a response is given (case 22421)

    Hello,

    Is there a way to send a ttl signal (to an EEG recorder) when a response is given?
    I know how to send ttl when stimuli are presenting. but is there a way to send ttl every time a response is detected?
    Last edited by jason_reed; 01-28-2016 at 11:56 AM.

  2. #2
    Join Date
    Feb 2013
    Posts
    1,093
    Hi RoyShoval!

    Take a look at the attached .csv input file for a set-up I think will accomplish what you want. I modified the sendttl.csv file that comes with the Samples folder of DirectRT (see this section of the DirectRT manual for more information: http://www.empirisoft.com/directrt/h...tl_signals.htm) if you want to try to run this.

    Each trial with a keypress starts off by asking for the user to press any key. As soon as that keypress is detected, each trial is then set up to do two things: send a ttl signal for 10 milliseconds and display a blank screen for 10 milliseconds. You can run this and then compare the amount of time that keypress took to make and the display and send times for the ttl signal and blank screen at the end of the trial with the data from the EEG recorder to see how they match up to test this possible solution. Of course, make sure that the port addresses in the attached file match those of your computer before running it.
    Attached Files Attached Files
    Jason Reed
    Empirisoft Software Support Specialist

Similar Threads

  1. Sending responses via TTL (case 5907)
    By AaronNewman in forum DirectRT Older Versions: How Do I...
    Replies: 5
    Last Post: 03-13-2013, 09:41 AM
  2. Sending TTL Signals (case 472)
    By jbeylev in forum DirectRT Older Versions: General Questions
    Replies: 2
    Last Post: 04-01-2012, 12:05 PM
  3. TTL suddenly not sending - I/O test not working
    By melc in forum Hardware: Troubleshooting
    Replies: 1
    Last Post: 10-08-2010, 12:57 PM
  4. Sending TTL signal from one computer to another
    By jarvis24 in forum Hardware: Troubleshooting
    Replies: 2
    Last Post: 11-12-2007, 05:52 PM
  5. Sending TTL to Coulbourn/Windaq Setup
    By kw272 in forum Hardware: How Do I...
    Replies: 6
    Last Post: 09-14-2007, 10:54 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •