Empirisoft Support

    Welcome to Empirisoft Support
Results 1 to 3 of 3

Thread: TTL SIgnals - Pins?

  1. #1
    Join Date
    Feb 2012

    TTL SIgnals - Pins?

    Hello, the docs say that DirectRT can send TTL signals through a PC port, but I can't seem to find any reference as to which pins on the port carry the TTL signal. I need this information in order to build a custom electrical circuit that would receive these signals. Any help will be appreciated.

  2. #2
    Join Date
    Nov 2005
    I'd refer you to this excellent overview:


    Summary: pins 2-9 are the data bus output. Pins 18-25 (inclusive) are ground.

    And also double-remember that these signals are quite weakly buffered. Add some current limiting resistors, and watch out for accidental short circuits.

  3. #3
    Join Date
    Feb 2012
    Thank you, much appreciated.

Similar Threads

  1. Sending TTL Signals (case 472)
    By jbeylev in forum DirectRT Older Versions: General Questions
    Replies: 2
    Last Post: 04-01-2012, 12:05 PM
  2. TTL Signals - Problem to communicate with an external equipment
    By aurelie Dommes in forum Hardware Questions
    Replies: 5
    Last Post: 08-18-2010, 10:08 AM
  3. Echoing key presses as TTL signals automatically
    By jarvis24 in forum DirectRT Older Versions: How Do I...
    Replies: 1
    Last Post: 06-15-2009, 02:23 PM
  4. Using a comma when receiving TTL signals?
    By jarvis24 in forum DirectRT Older Versions: Troubleshooting
    Replies: 1
    Last Post: 10-02-2006, 09:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts