-1 Response in data file

[mbeatriz]

I figured it out....I guess I didn't have to worry about the min-max values, all I needed was the clear500 command..duh...

Thanks!

[mbeatriz]

Disregard previous post...It happened again.

Attached is data file.

Tahnks!

[jarvis24]

Take a look at the response time on the first ten rows of the data file. See that it says -1 only for the trials on which your subject exceeded the maximum RT? If you are using a min-max value of 0-500! and you see an RT of 501, that means the subject did not respond within the first 500ms of the trial. Does that makse sense?