Dear all,
I would like to run PEBL (http://pebl.sourceforge.net/) from medialab. I have seen that there was a post about this sometime earlier (http://support.empirisoft.com/showth...highlight=pebl), but this post seemed to be "solved" before the true solution was found . So here is the question: PEBL allows running script files using simple batch files. The command line in the batch file I am using looks like this:
"C:\Program Files\PEBL\bin\pebl.exe" bat.pbl --display 1024x768 -v 100 --language en --fullscreen
--> the quoted part is the program location.
--> bat.pbl is the experiment script I'd like to run within medialab
--> --display 1024x768 specifies the display size
--> -v 100 specifies participant number. Ideally, I would like to set this automatically to the current participant number in medialab
--> --language en specifies the current language
--> --fullscreen specifies that PEBL is run fullscreen
So far, I have created an experiment that starts the program (the quoted part above). However, I wasn't able to figure out how to start the specific experiment script (bat.pbl), and I have no idea on how to specify the addl parameters. Any ideas.
Finally: We are using ML 2004, should that be relevant information.
Many thanks, best, Rainer