Empirisoft Support

    Welcome to Empirisoft Support
Results 1 to 3 of 3

Thread: Having Problem with TTL, Parallel Port, I/O test

  1. #1
    Join Date
    May 2010
    Posts
    4

    Having Problem with TTL, Parallel Port, I/O test

    To I/O test, I followed the instruction of Media Lab. When everything was connected and opened the IO test page, LPT1:error, LPT2:error, and LPT3:error showed. I even entered 888, it didn't work.

    What else should I do? I am using Media Lab on Windows 7.

    Thank you,
    Last edited by jarvis24; 12-13-2010 at 10:45 PM.

  2. #2
    Join Date
    May 2010
    Posts
    4
    As a follow up, these errors are still occurring even when the cable is removed from the desktop. It seems that the Media Lab software (IO test) doesn't even recognize LPT ports in Windows 7. Could you help?!

    Jung

  3. #3
    Join Date
    May 2010
    Posts
    4

    More information about my system

    Can you please provide detailed parameters with respect to the parallel port interface for use with the Media Lab software under Windows 7? Here are some of the settings under Windows 7 and in the Bios that we have control over.

    Bios: ECP, EPP with DMA (two variants), EPP without DMA or legacy AT/PS2 settings.
    Bios: set the base address of the single printer port between the standards for LPT1, LPT2 and LPT3.

    Windows 7 Enable/disable legacy plug and play for parallel port
    Windows 7 Let windows automatically manage base address, IRQ and other settings
    Windows 7 Require or prevent use of interrupts for the parallel port
    Windows 7 Manually set a base address
    Windows 7 Manually set an IRQ assignment

    We have confirmed that we are getting an approximately 5V signal through the cable where it connects the biopac to the computer so the cable appears to be ok. We also connected a parallel port printer to that same port on the computer and the printer printed fine. At present we are still getting ‘LPT1 – error’ when we attempt to test it via the IOTEST.exe utility. Manually forcing to 888 (378h) for a port value didn’t help either. At this point it appears to be either a windows/bios setting that needs to be adjusted just to accommodate the Biopac signaling or a problem within the Medialab program. All the hardware and all other applications seem to work fine with this parallel printer port under generic Windows 7 default settings.

Similar Threads

  1. TTL suddenly not sending - I/O test not working
    By melc in forum Hardware: Troubleshooting
    Replies: 1
    Last Post: 10-08-2010, 01:57 PM
  2. TTL-Problems with PCI-parallel port card
    By Thomas in forum Hardware: Troubleshooting
    Replies: 4
    Last Post: 05-10-2009, 02:25 PM
  3. TTL problems: I/O Test
    By Roelie in forum Hardware: Troubleshooting
    Replies: 6
    Last Post: 11-12-2008, 01:31 PM
  4. Parallel port address can not be read
    By bollsp in forum Hardware Questions
    Replies: 7
    Last Post: 11-11-2008, 10:13 AM
  5. Parallel Port and Vista
    By bollsp in forum Hardware Questions
    Replies: 0
    Last Post: 10-30-2008, 02:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •