Empirisoft Support

    Welcome to Empirisoft Support
Results 1 to 2 of 2

Thread: Communicating with PowerLab hardware: TTL

  1. #1

    Communicating with PowerLab hardware: TTL

    Hi
    My participants will be asked to complete an online survey with embedded film clips while psychophysiology recording is taking place concurrently.

    I have read the TTL info in the MediaLab manual, and would like to be able to send info from MediaLab during my experiement to my PowerLab hardware or Chart software. But I can't figure out how to do this! I have attempted to use the IOTest.exe as recommended to test whether I can send signals, but when I do this, the only ports that come up say "Error". Do I need to set up ports somehow in advance?
    I would appreciate any help with this, or advice RE the best way of sending signals between MediaLab and PowerLab.
    Thanks.

  2. #2
    Join Date
    Nov 2005
    Posts
    294
    Howdy,

    I'd first point you to this thread in the MediaLab forum:

    http://www.empirisoft.com/support/showthread.php?t=131

    It's for an eye-tracking system, but the concepts are the same.

    Which port are you trying to communicate through? Serial? Parallel? What address are you entering in the IOTest utility?

    John

Similar Threads

  1. Sending responses via TTL (case 5907)
    By AaronNewman in forum DirectRT Older Versions: How Do I...
    Replies: 5
    Last Post: 03-13-2013, 09:41 AM
  2. Using a comma when receiving TTL signals?
    By jarvis24 in forum DirectRT Older Versions: Troubleshooting
    Replies: 1
    Last Post: 10-02-2006, 09:08 PM
  3. DirectIN Hardware in Parallel with Existing Keyboard
    By JEC in forum Hardware: Troubleshooting
    Replies: 0
    Last Post: 01-11-2006, 02:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •